There is a golden rule when it comes to BIM software: "Just because you can, doesn't mean you should". We can definitely achieve a similar solar study result in Revit, but one has to carefully weigh the time spent to the actual benefits. Will the seconds/minutes/hours I spend be billable, or will it be seen as a value added service? I will leave the decision up to you.
This Revit Recess entry will explain the steps taken to achieve a result as per the origional ACF post.
12-off 3D views were created, each with its Sun Path enabled. Each 3D view was set to a different month - starting with January and ending with December.
A presentation sheet was created and each view placed on the sheet in the same position. (TIP: One can actually snap to the center of views which were placed on a sheet). As we can see from the image below, the sun paths create quite a "busy" view.
By selecting 11 solar study 3D views and disabling the sun path, one will achieve a much neater representation.
The end result does look great, though!